CrossRef 31. El-Shanahoury IA, Rudenko VA, Ibbrahim IA:

Polymorphic behavior of thin evaporated films Selonsertib in vitro of zirconium and hafnium oxides. J Am Ceram Soc 1970, 53:264–268.CrossRef 32. Kim JS, Marzouk HA, Reucroft PJ: Deposition and structural characterization of ZrO2 and yttria-stabilized ZrO2 films by chemical vapor deposition. Thin Solid Films 1995, 254:33–38.CrossRef Competing interests The authors declare that they have no competing interests. Authors’ contributions GB carried out the experiments for the growth and optimization of multilayer films and drafted the manuscript. PK carried out the experimental analysis. DS participated in the experimental measurement. JIS participated in its design and coordination. All authors read and approved the final manuscript.”
“Background The electrical and structural properties of hydrogenated amorphous Si, Ge and SiGe are particularly affected by the hydrogen incorporated and its bonding configuration. On one hand, H has proven to be very efficient in reducing the density LCZ696 in vitro of open dangling bonds responsible for deep levels in the bandgap. By hydrogenation, their density can be reduced to 1015 to 1016 cm−3 in a-Si [1], which is quite acceptable for device applications, e.g. in photovoltaic solar cells [2]. On the other hand, the H bonding configuration

may negatively affect the microstructure of the amorphous lattice. In a-Si, hydrogen is bonded in two modes: as randomly distributed H bonded at isolated network sites (passivating the dangling bonds) and as H bonded in the form of clusters [1, 3–6]. Smets found that H is silicon-bonded in hydrogenated di-vacancies [1, 7] for low H content. Alternatively, the H clusters are accommodated on the surfaces of voids larger than di-vacancies next [4–6]. Nano- and micro-voids

have been detected in a-Si [5, 7–10] as well as in a-Ge [11]. Such voids are normally present in as-prepared amorphous materials. As also recently pointed out by Beyer [7], voids are still one of the major defects in hydrogenated a-Si. Being empty spaces, they cause density reduction that can change the refractive index, electronic defect states [7] and anomalous stress distribution especially if filled with H [12] or if they form Si-H platelets [13]. Furthermore, the mentioned H clusters that are situated on the inner surfaces of voids can give rise to potential fluctuations in the bulk that deteriorate the electro-optical properties [14, 15]. In a-Si, an increased concentration of Si poly-hydrides, e.g. Si-H2 di-hydrides, was seen to increase the optical bandgap [6] and decrease the refractive index [16]. Voids, and related H bonding configurations, are also believed to be involved in the Staebler-Wronsky effect [17, 18], i.e. degradation of the hydrogenated a-Si properties upon illumination [1, 9]. According to Beyer, cavities in the material are most crucial if they are large enough to accommodate H molecules [7].